Spare wheel holder, 4x100, horizontal mounting on the wheel arch

Product detailed description

• The bracket is used to mount the spare wheel in a horizontal position on a steel profile 35 to 70 mm wide, the mounting brackets are not included.
• Compatible calipers can be found below in related items.
• The holder is designed for 100x4 wheel mount (four-hole mount, axial spacing of wheel bolts measured through the wheel centre is 100 mm)
• The oval holes in the holder allow the holder to be attached with calipers with an internal width of 36 mm to 70 mm
• Attention! The bracket must be mounted so that the wheel is fixed in a horizontal position. The product is not intended for mounting the wheel in a vertical position.
• For a maximum tyre width of 165 mm with a rim clearance of IS(ET) 30. Higher spare wheel rim clearance reduces the maximum possible tyre width proportionally
• The bracket is supplied with two M12x1.5 wheel bolts with tapered seating surface. In the case of discs with ball seating surfaces, we are happy to replace them with M12x1.5 screws with ball seating surfaces - in this case, please specify the request in the order notes.